• Up • Aquarium FAQ and Tropical Fish Information • General Aquarium and Tropical Fish Bookstore • Aquarium Water Chemistry • Aquarium Plants • Common Aquarium Plants • Commonly Available Tropical Fish • Tropical Fish Diseases • Aquarium Fish Anatomy • Tropical Fish Foods • Shipping and Receiving Tropical Fish • Saltwater Aquarium Information • Public Aquariums •
Under an assumption that many
visitors to this section are new hobbyists or those wishing to take some next steps we're
not going to make this any more technical or complicated than necessary. Basically
it boils down to what to test for, how often and the wisdom for weekly water changes.
kits which can be obtained on-line, or at a local pet
shop, ultimately prove cheaper than fish.
The best prevention and remedy
for high levels of ammonia, nitrates, nitrites and other chemicals, is a regular weekly
10% water change. I also recommend that as you let your water sit to remove chlorine
from tap water that you add a little aquarium salt to this water. Please note, if
you only add water that was evaporated, DO NOT add more salt, because salt does not
evaporate and you will then be raising the salinity of your water over time. I
usually add about 1/3 to 1/2 tsp. of aquarium or seasalt
to a gallon of water I am
replacing. Aquarium salt or seasalt also contains the minerals and trace elements
that fish need to thrive. Even freshwater fish need some salt in their water.
I would also add a little white vinegar, if I am using tap water, because I've found that
most city water has a pH of 7.8, which is alkaline. I add the vinegar to lower the
pH to about 7.0 - 7.2.
I likewise add my aged
replacement water over a period of about 10 min, certainly for my more sensitive
fish. You'll find this weekly practice of replacing 10% of the water in your
aquarium is the best thing you can do to insure the health, color and
reproductive viability your fish. God gives the fish water changes, it is called rain! One of the
most common 'tricks' that fish breeders use is a water change to induce spawning. A
gallon of bottled water (certainly soft water) or distilled water is fine to use, but
isn't absolutely necessary, unless you are trying to spawn difficult fish, who require soft
In a newly set up aquarium, water
testing is a must. First to see what conditions you have and to prevent the usual 'new
tank' fish loss, because ammonia, nitrites, and other variables rapidly rise.
Another common 'new
tank' experiences is that once fish start dying, anaerobic bacteria (the type that
make the tank stink) rise as there are not sufficient population of aerobic (air
breathing) bacteria to keep the anaerobe populations down.
Even in an established tank,
water testing is necessary to promote the color, breeding and general health of your fish.
As you know different species of fish come from different areas of the world,
different climates and different water conditions. The links to the fish on the right,
describes some of these conditions.
kits can either be obtained at your local pet shop
or on-line here and you'll find they are really very simple and inexpensive.
Certainly cheaper than a tankful of fish. If you really aren't sure, visit your
local fish shop and ask them to test your water. Some charge a nominal fee
So what do you test for?
The tests I've found most useful to the average hobbyist (certainly for those wishing
to breed fish) are Ammonia, pH, Nitrite, and Nitrate. Salinity and hardness
levels should also be considered, but if you do weekly water changes of 10% or more and
replace the aquarium salt to cover the amount removed per gallon (marine/saltwater
fish are different per salinity concerns) you shouldn't really need to worry about
these too much.. It is a good idea, certainly if you wish to maintain more than one
aquarium, to keep a log for your aquarium writing down such things as testing levels,
number of fish, condition of fish, spawns, etc.
pH is the the measure of how acid, neutral or alkaline the
water is. 7.0 is neutral and anything less is acidic and anything over 7.0 is
considered alkaline. This is an important water chemistry consideration for the
health of your fish and it is crucial if you wish to encourage them to spawn. Fish cannot
tolerate sudden changes in pH. Even a small change of .2 can result in stress or even
death if it occurs suddenly. When you add fish slowly to the aquarium after bringing
them home, after you've let the water temperatures equal, you do this slowly to slowly
change the pH. pH will change with time. Fish and plant waste, water
evaporation, water addition, and other populations of organics will effect changes in the
Water hardness refers to the amount of calcium and magnesium
salts present in the water. Too much hard water causes a white crust to form on parts of
the aquarium. Hard water makes it difficult to adjust the pH. Products are available to
help soften the water. You can also lower water hardness by using soft bottled water or
Although salt is associated with marine aquariums, freshwater
aquariums can benefit from small doses, as well. A lack of sodium (salt) in the water will
break down the slime coat of fish. One tablespoon per five gallons will provide enough
salt for most fish. Mollies, Swordtails, Tetras, Fancy Guppies, and Goldfish prefer a
little more. Cichlids, Knifefish, and Ghosts prefer less. Only use salt that is
recommended for aquariums. Never use regular table salt which may contain iodine.
Chlorine and Chloramine
Chlorine is found in most tap water and must be neutralized with a
water treatment that removes chlorine.
Chloramine is a combination of chlorine and ammonia. It is a stronger
disinfectant than chlorine alone and is used in areas where this extra disinfection is
needed. You can call your local water department to find out if chlorine and chloramine is
in the water, or you can buy a Chloramine/Chlorine test kit at your local pet shop or
on-line through some of our recommended pet shops
Testing for ammonia is one of the fundamental tests of
aquarium water. Ammonia will be higher during a new
tank cycle, but can also increase in established tanks if the water is not changed
regularly, filters are not kept clean or become clogged, if their are too many fish, or if
medication is used that disrupts the biological cycle, such as an antibacterial agent
killing off large aerobic (the good kind) bacteria. In an established tank, an ammonia
test should be performed and recorded in a log once a month. Anytime you have sick fish,
or a fish death, you should immediately test for ammonia. This is certainly true, if
you loose your scavenger/catfish or others that inhabit the lower strata of the aquarium.
At concentrations as low as .2-.5 ppm (for some fish), ammonia causes death
Even at levels above 0.01-0.02 ppm, fish will be stressed. If the ammonia is a
problem it must be dealt with immediately with a 20% change of aged water to reduce the
toxicity and harm to your fish.
During the startup of a new tank, Nitrite, as is true of
ammonia, levels will soar and can stress or even kill fish, as the aquarium's cycles begin
to establish themselves. However, even after an aquarium is initially cycled, it is not
unusual to go through mini-cycles from time to time, just as populations of fish cycle.
When you do your monthly testing, include nitrite testing as part of the routine. Any
elevation of Nitrite levels is a red flag that indicates a problem brewing in the tank. If
a fish is ill, or dies, it's wise to test for Nitrite to ensure that is not contributing
to the problem. The only way to reduce elevated Nitrite levels quickly is via water
Although Nitrates are not as toxic as Ammonia or Nitrites, they must be monitored to avoid
stressing the fish. Nitrates can also be a source of algae problems. Nitrates will rise
over time and can only be eliminated via water changes. Monthly tests are important
- particularly when breeding fish, as young fish are more sensitive to Nitrates than adult
Test monthly and keep levels low to ensure a healthy tank.
If your aquarium is prone to rapid growths of algae, excessive light and phosphate levels
are usually factors. Phosphates serve as a nutrient for algae. If your phosphate levels
are high, check the dry fish food you are using, since general feeding, emphasis
overfeeding, with lower quality foods high in phosphates, will raise these levels in your
water over time.. If algae is getting the better of you, test for phosphates, reduce the
amount of light, emphasis direct sunlight and take the more natural approach to
algae by getting a scavenger (i.e. Chinese Algae Eater), rather than add more chemicals to
& Conditioners Calculate Volume
Tank Volume Calculator
Calculate DH Calculate Water Hardness